Double Facer

Additional Details

The double facers offered by us are used to make perfectly bonded board. The liners are heated and transported to the double facer free of stress due to the pre-conditioner. The hot plates stay completely flat for steady heat transfer over the entire working width without edge crush in all operating conditions. Different numbers of hot plates can be configured in heating section according to requirements of our clients. Further, the pressure rolls of cooling section make sure perfect forming quality. The specially designed feed geometry aid in eliminating bubbles & ripples in the liner and conditions it prior to bonding. Designed to have low friction properties, these facers are highly corrosion resistant.

Technical Specifications

• Flow of steam/oil within the Hot Plates ensures even heat transfer across the full surface and minimum loss of energy

• Pressure rolls can be adjusted in micron individually depending upon the grade of board & speed of production

• The upper and lower Double Facer Belts are synthetic

• The belt is mechanically or pneumatically lifted from the hotplates when the machine stops

• Rubberized /M.S. Puller Rolls are used

• The upper and lower belt drums are driven by synchronizing with cut-off

• The drive rolls are wrapped with double helically grooved rubber, in order to increase the traction of belts