Additional Details
Specification Part - 2 10 Hz - 99.99 Hz Power Less than 30 Watt.0.1 Hz consumption100 - 208 Hz Dimension 21 x 12 x 12 cm Accuracy ± ( 0.15 % + 0.2 RPM ) rdg. ( 8.3 x 4.8 x 4.8 inch ).< 1,000 RPM Weight 1Kg/2.2 LB.± ( 0.5 % + 1 RPM ) rdg. Housing case Compact and impact plastic1,000 to 3,300 RPM injection case with plastic ± 1 % FS. mirror type reflector. 3,301, to 12,500 RPM Calibration Crystal time base and rdg : reading, FS : full scale microprocessor circuit, not Switch Select RPM, Hz necessary take any external Function Fine adjust, Coarse adjust, calibration procedure if the Multiply by 2, Divide by 2, stroboscope working properly.Fast finder, Memory recall. Accessories Operation manual........1 PC.Memory Can memorize 10 sets of included Power cord................. 1 PC. measuring data. Optional Accessories * RS232 cable.........UPCB-02Set up stability 1 digit within 10 minute. * USB cable............ USB-01.Data output RS 232 computer interface. * Data Acquisition software Operating temp. 0 to 50 (32 to 122 ). ...........................SW-U801-WIN.Operating humidity Less than 80% R.H. Operating duty For prolong life and safe operation, please adhere to the following duty cycle: Cycle < 2000 RPM - 2 hours, 2000 to 3600 RPM - one hour, 3601 to 8000 RPM - 30 minutes, > 8000 RPM - 10 minutes. * 10 min. cooling off period between cycles. FLASH TUBE SPECIFICATIONS Flash tube Xenon lamp. Flash tube It is required to change the Flash Duration Approximately 60 to 1,000 replacement flash tube when the microseconds. instrument start to flash Flash color Xenon white 6,500 K degree irregularly at speeds of 3600Flash energy 4 Watts-seconds (joules). RPM/FPM or more.Beam Angle 80 degrees. OPERATIONS PROCEDURES Preparation (a) Plug unit into a properly grounded 110V AC, 220V AC or 230V AC outlet.(b) Turn the power switch to " on " position.(c) Determine the range switch to " Low " or " High " position.Checking Speed When checking speed, care must be taken to insure that the strobe is flashing in unison (one to one) with the object being monitored. A Stroboscope will also stop motion at 2:1, 3:1, 4:1 et., this is normally referred to as harmonies. To be sure of unison, turn the dial until two images appear - this will double the actual speed. Then lower the flashing rate until a single and stationary image appears - this is the actual true speed.Checking Motion For motion analysis, simply locate the actual speed as mentioned above and then turn the dial slowly up or down. This will give a slow motion effect allowing complete inspection. Remark When order the stroboscope, should inform the power supply type is AC 110V, or220 V or 230V.
India
 rdg. ( 8.3 x 4.8 x 4.8 inch ).< 1,000 RPM Weight 1Kg/2.2 LB.&pl){kind=link}