Welcome to Pepagora.com, Join FreeSign In
OXYGEN GAS PLANT
NITROGEN GAS PLANT
ACETYLENE GAS PLANT
NITROUS OXIDE GAS PLANT
HYDROSTATIC CYLINDER TEST STATION
EXPANSION ENGINE
The Expansion Engine is vertical, single acting, triple expansion engine, reciprocating type. This produces the cold required for the plant. High- pressure air enters through inlet valve at the start of downward stroke of the piston.
The Expansion Engine is vertical, single acting, triple expansion engine, reciprocating type. This produces the cold required for the plant. High- pressure air enters through inlet valve at the start of downward stroke of the piston. On further downward motion, the inlet valve closes and entrapped Air expands. During upward stroke, outlet valve remains open and inlet valve remains closed.
Therefore, in downward stroke Air enters the cylinder and expands. In the upward stroke the expanded air is pushed outside. The electric Motor is used to start the machine. Thereafter the Engine is moved by the Air pressure itself and during which time, the Engine motor retains the speed by acting as a brake. Since work is done by Air in rotating the flywheel, it loses itsexpansion engine manufacturer heat content (enthalpy), thus the Air gets cooled. This cooling is more than that of an expansion in an Expansion Valve.
An elementary factor for the function of an Expansion Engine is to use dry and carbon Dioxide free Air, as otherwise, ice and dry ice will form on valve seats, causing mal-function. The approx. temperature drop across Expansion Engine is 50 to 70°C, depending on inlet air pressure, temperature and inlet cam position.
The Expansion Engine manufacturer consists of three major units.
The drive unit
The cylinder unit for Air expansion
The Hydraulic system for operating the valves
The drive unit is similar to any reciprocating machine with usual parts. Such as, crank case, crankshaft, connecting rod, crosshead, etc. The Expansion Engine has an extended crankshaft enabling the accommodation of the cam box. The moving parts are lubricated through a hole in crankshaft. Oil scrapper rings are provided to prevent oil escape to cylinder unit
The cylinder unit handling the process Air consists of cylinder, piston, inlet and outlet Isolation Valve Assemblies. The Ball valves are actuated mechanically by a Push Rod as per the timing transmitted by the cam. The Push Rods are housed in a stuffing box to avoid Air leakage and are actuated by the hydraulic system.
The Hydraulic system is the control system. The Hydraulic oil is fed by a pump to:
Pressurized oil container for valve actuation.
Lubricate crankshaft and drive and drive unit parts .
Lubricate the rolled holders .
